HOT WATER BATH WITH STIRRER

HOT WATER BATH WITH STIRRER

Double walled construction with inner wall made of 18 SWG stainless  steel (SS 304) and outer of 16 SWG  mild steel with epoxy powder coated finish. Space in  between  the chambers will be properly ceramic wool   insulated. Inlet  and outlet  for water filling and  draining with Top S.S lid.

Fitted with Motorised stirrer for uniform temp.in side the Bath.Low water level auto cut off.The boiling temp. will reach within 30min.for full Capacity. Temperature is Controlled by a microprocessor based PID controller



A. Temperature Range: Above Ambient to 100ºC with 0.1ºC Resolution.

Display                       : Digital display of 'SET'& 'PROCESS' TEMP.

Size of the bath        :  600mm (L) x 500mm (W) x 500mm (D)

Load                           : 7-8 KW.

Suitable to work on single phase 230V AC 50 Hz.



B. Temp. Range from + 5ºC above ambient to 100ºC

Display                       : Digital display of 'SET'& 'PROCESS' TEMP

WORKING SPACE SIZE : 500mm L x 300mm W x 300mm H

Load : 3 - 4 KW

Works on  single  phase 230V  AC mains, 15 amps, 50 Hz.

Complete with  Stirring  assembly with  TEFC Motor for

temperature uniformity.



C. Temperature Range: Above Ambient to 100ºC with 0.1ºC Resolution

Display                              : Digital display. Accuracy: 0.5ºC.

Size of the bath                : 1000mm (L) x 750mm (W) x 750mm (D)

Load                                  :  8-9 KW.

Timer                                 : 99hours timer for auto cutoff

Water level controller      : for Low level alarm and cutoff

Suitable to work on 3 phase 440V AC 50 Hz.